TOP INCORPORATED COMPANY

@

Dryer

Dryer is using for dry up, dehydrate, soften or harden etc. Make the thing, which is respectively suitable by the use.

(using temperature 250)

Use this machine when you heat the thing of the same quality in quantity on the same condition. It cans operation 24-hour, if carrying in, carrying out are automated and it is included into the production line and temperature and time are set up. A safety countermeasure is also available.

@

@

 

Plastic melting dryer

This machine uses a ceramic far-infrared ray heater therefor; plastic board becomes soft in a short time. (there are no relations in the quality of the material of the plastic board, the color, and so on by using the ceramics infrared heater) And, a running cost can be reduced because it is finished with about 70% of the consumption electric power in the case as the dryer of the same size when it is compared with the quartz pipe heater and so on.@

 

Hot air circulation dryer

Hot air circulation dryer is circulating hot air by the ventilator. This type's of dryer is much better than the directly heating, because a few heating loss. When add switching valve, it can dry organism solvent. The circulation air is changeable upper to lower or right side to left side.

@

@

 

Heat molding machine

This machine uses a ceramic far-infrared ray heater therefor; plastic board becomes soft in a short time. (It becomes soft in a thickness 3mm of the vinyl chloride in about 1 minute 30 seconds.) At first, plastic board put into a furnace, which is under the body. When time is up (buzzer is buzzing) mold it with the hydraulic press at the upper of the body if it becomes soft. The timer and presser strokes are changeable.

@

@

 

Vacuum molding machine

This machine is capable of implementing blow molding, vacuum molding, and heat molding. The waiting time of heating the plate has been eliminated with the development of the two rotary type stations, enabling laborsaving and a reduction in the production cost. For instance, it is possible to produce one plate of 2 to 3 mm in thickness in 120 to 140 seconds. Moreover, the waiting time may be reduced even when the room temperature is high by spraying air on the metallic mold.

@



E-mail info@topinc.jp

@